Page 90 - 世霸SuperToolVol.6

Eccentric Cone For new
cooling media
■ Flaring process dimension standard
Type Flare Pipe dia. A size
+0
Size Diameter Pipe dia. A size（ −0.4）
Flaring cone name name
Eccentric Gauge For 1 st category For 2 nd category
cone bar
1/4" 6.35 9 9.1
The precision finished
3/8" 9.52 13 13.2
flaring cone, using
eccentric rotation, assures 1/2" 12.70 16.2 16.6
an equal flaring by the 5/8" 15.88 19.4 19.7
cone side, allowing an 3/4" 19.05 23.3 24.0
evenly neat flaring even Copper
st
with low force. pipe ＊ 1 category : R407C(E), R404A, R507A, HFC134a and conventional cooling media
nd
＊ 2 category : R410A
PIPING TOOLS
TF456WQH
■ FLARING TOOL WITH QUICK HANDLE
(Eccentric Cone Type) PAT.

Tube Adapted to new standard / new cooling media
cutters
Features
● Adapted to annealed copper pipe 3/4’’, thickness 1.2mm.
Other ● With the quick handle, no need to change the handle hold,
cutters
the hands don’t get tired and continuous rotation is easy.
● You can change the rotation direction quickly by
sliding the handle up and down.
Pipe scrapers, ● As there is no switch knob at the center of the handle,
super torque
wrenches the handle just fits the hand with no discomfort.

● No backlash thanks to special bearing used in the
rotating part of the handle.
● Clutch mechanism used in the center of the body
Flaring tools
enables high precision flaring.
Example
Flanging of use
tools for
flexible tube

Benders
◀ To switch the
rotation direction,
just slide the handle
Chain pipe up and down.
wrenches
Copper pipe applicable diameter (size name) N.W.
Item No.
Pipe (copper pipe for general cooling media piping) （kg）
wrenches,
belt TF456WQH 1/4 ・ 5/16 ・ 3/8 ・ 1/2 ・ 5/8 ・ 3/4 1.7
wrenches
Motor
wrenches,
other Operation procedure
wrenches
Push down Lift up
clamp
Water pump
pliers handle
gauge
bar Turn right
or repeat Turn left
copper
Super pilers, turning or repeat
threaded pipe turning
rod cutters
1) Open the gauge bar to 2) After pushing down the handle to 3) After lifting up the handle to 4) Loosen the clamp
the left and right and the end, turn right until the clutch the end, turn left and return the handle, open the gauge
insert the copper pipe. gets disengaged. handle completely until it stops. bar to the left and right
Plumbing In this case, you can turn continuously In this case, you can turn continuously and remove the copper
tool set without changing the handle hold. without changing the handle hold. pipe.
＊ The operation procedure above is an excerpt from the operation manual. Always read the operation manual and follow the instructions before use.
88 ●For all the appendix of the piping tools, please refer to P.283