Page 140 - 日本前田TONE

For manual
6.35 Head pivots can be refracted by 90 degrees on either side of the SHORT SPINNER HANDLE
pin at the head of the handle, and can be adjusted by 15 degrees.
When turning quickly by temporary tightening, etc., you can use
the handle to stand up, and you can tighten it by turning the Square Dimensions (mm)
handle to the side. Models Drive Qty./Carton Weight
(Generally)
(g)
For repair by yourself you can purchasing a repair kit. (mm) D L
Design handle has been registered. NS2S 6.35 16.2 100 6 65
Good Design award %
6.35 ̡
mm
1/4 NS2S
SPINNER HANDLE

Square Dimensions (mm)
Models Drive Qty./Carton Weight
(Generally)
(g)
(mm) D L
NS2 NS2 6.35 16.2 150 6 95
Good Design award %
̡

LONG SPINNER HANDLE
NS2L

Square Dimensions (mm)
Models Drive Qty./Carton Weight
(g)
(Generally)
(mm) D L
NS2L 6.35 16.2 200 6 115
Good Design award
＜ Example ＞

%
̡

CAUTION
● Do not over torque, as the whole lenghth is long enough to apply excessive load.
90 degree refraction on both sides

■Repair kit for Spinner Handle
Models RK-NS2
Suitable model : NS2S, NS2, NS2L
Parts table No.1-4 is one set.
■ Parts table
NO. Descriptions Qty.
● 1 Driving part 1
● 2 Pin 1
● 3 Latch 1
● 4 Spring 1
CAUTION
● Repair may be difficult for the general public.

The angular drive head can be used at any angle, refracting SPINNER HANDLE
90 degrees on either side of the pin at the head of the handle.
When turning quickly by temporary tightening, etc., you can use
the handle to stand up, and you can tighten it by turning the Models Square Dimensions (mm) Qty./Carton Weight
Drive
handle to the side. (mm) D d L (Generally) (Store Center) (g)
111 6.35 13 6.5 150 10 6 100
6.35 Spinner handle 111 can be used as a T-shaped wrench in combination with cross bar 112 (P.141).
mm
1/4

111

CAUTION
138 'PS IBOE UPPM ● Avoid giving shock by hitting with hammer etc..
● Insert square drive positively to the bottom.